What is how to clean front load washer?

Here's some information on how to clean a front load washer:

Cleaning Your Front Load Washer

Front load washers require regular cleaning to prevent mold, mildew, and unpleasant odors. Here's how:

Wipe Down the Door and Seal: After each wash, wipe down the rubber gasket (also known as the door%20seal) thoroughly. Pay special attention to the folds and crevices, as this is where moisture and debris tend to accumulate. Use a cloth and a diluted bleach solution (1 part bleach to 10 parts water) or a commercial washer%20cleaner.
Clean the Dispenser: Remove the detergent and fabric softener dispenser drawers and clean them. Rinse under warm water to remove any residue buildup. Scrub with a brush if needed. Allow to dry completely before replacing.
Run a Cleaning Cycle: Most front load washers have a dedicated cleaning cycle (often called "Tub Clean," "Washer Clean," or something similar). Follow the manufacturer's instructions for running this cycle. Typically, you'll add a cup of bleach or a commercial washer cleaner to the dispenser. If your washer doesn't have a cleaning cycle, run a normal hot water cycle with an empty drum and the cleaning agent.

Clean the Gasket Thoroughly: For a more thorough cleaning of the rubber%20gasket, use a stronger bleach solution (1:1 ratio) or a commercial mildew cleaner. Wear gloves and eye protection. Carefully scrub the gasket, paying close attention to the underside and any hard-to-reach areas. Let the solution sit for a few minutes before wiping clean with a damp cloth.
Clean the Filter: Locate the washer%20filter (usually located at the bottom front of the machine behind a small access panel). Place a towel or shallow dish in front of the panel to catch any water that may spill. Carefully open the access panel and remove the filter. Rinse the filter under running water to remove lint, debris, and small objects. Reinstall the filter securely.
Check and Clean the Drain Hose: Inspect the drain hose for any kinks or clogs. If possible, detach the hose and flush it with water to remove any blockages.

Leave the Door Ajar: After each wash, leave the washer door slightly ajar to allow air to circulate and prevent moisture buildup.
Use the Correct Amount of Detergent: Using too much detergent can lead to residue buildup and contribute to mold growth. Follow the detergent manufacturer's instructions and use the appropriate amount for your load size and water hardness.
Use HE Detergent: Front load washers require High Efficiency (HE) detergent, which is formulated to produce fewer suds. Regular detergents can create excessive suds that can trap dirt and moisture.
Dry the Interior: After running a cleaning cycle, wipe down the interior of the drum with a clean, dry cloth.

By following these cleaning tips, you can keep your front load washer fresh, clean, and free of odors.